Franke Instant Boiling Water Tap Installation Service

Please have the following details available:

• Name
• Installation address
• Telephone number
• Email address

Next available appointment, no earlier than a specified date, or another requested timing.

Please let us know in advance if there are:

• Parking restrictions
• Permit requirements
• Loading restrictions
• Limited site access arrangements

A 35mm tap hole must be prepared before the installation appointment.

The following water pressure is required in accordance with the product installation instructions:

• Maris: between 1 and 5 bar
• Mythos: between 1 and 10 bar
• Mythos Pulse: between 1 and 5 bar

Where required, a pressure reducing valve can be supplied and fitted at an additional cost.

• Hot and cold water supplies available within the sink cabinet.
• Both supplies fitted with 15mm isolation valves.

If a hot water supply is not available, a Warm Water Support (WWS) mixing valve may be fitted at an additional cost, where suitable.

Waste plumbing must allow 120mm of vertical or horizontal push-fit pipe, positioned as low as possible, for fitment of the tundish waste pipe connector and spigot. An 80mm vertical drop is also required for fitment of the PRV tundish and pipe.

Power socket(s) must be available inside the cupboard as follows:

• Maris Mechanical System: 1 x 13A socket
  
  
• Maris Electronic System: 2 x 13A sockets
  
  
• Mythos: 1 x 13A socket
  
  
• Mythos Pulse: 1 x 13A socket

Minimum cupboard dimensions:

• Maris: H400 x W400mm
  
  
• Mythos: H450 x W400 x D550mm
  
  
• Mythos Pulse: H600 x W450 x D520mm

NB Tanks cannot be installed horizontally or beneath the plinth.

Please ensure adequate space for the selected system:

• Maris 4 litre tank: H340 x W229mm
• Maris 7 litre tank: H494 x W229mm

• Mythos: H400 x W200 x D 495mm
  50mm required at rear for ventilation. Additionally, a W200 x H400mm cut out of cupboard at rear is required.

• Mythos Pulse: H502mm x W211mm x D484mm
  50mm space required each side for ventilation.

• Maris: Allow space for the hydraulic box/boxes (90 x 87 x 73mm) and filter head with filter (295 x 95 x 95mm). These components must be secured to the back or side wall of the cupboard.
  
  
• Mythos: Filter consumables are contained within the tank device.
  
  
• Mythos Pulse: Allow space of H430 x W90 x D200mm for the filter and CO2 units.