Toilet: HDWC2414-RM

This Heavy Duty Water Closet (Toilet) is designed for areas requiring the utmost in vandal resistance. The fixture is fabricated from heavy 14 gauge (2.0 mm) type 304 (CNS 18/10) stainless steel. The elongated bowl is drawn and seamlessly welded and polished to a #4 satin finish. The toilet seat is polished to a sanitary mirror finish. Internal piping is also 14 gauge (2.0 mm) type 304 (CNS 18/10) stainless steel. Elongated design blow out jet bowl.
The toilet requires a minimum of 35 PSI flow pressure. The toilet was tested and certified as a low water consumption toilet using only 1.6 gpf (6 lpf). The trap will pass a 2 1/8" (54 mm) ball and has a seal of 3.5" (88.9 mm) min. The waste outlet extends a minimum of 3" behind the fixture and has a plain end OD of 2 3/8" (60.3 mm). Flush valve connection is 1 1/2" (38.1mm) FIPT rear spud.
INSTALLATION:
These fixtures are designed to be installed onto finished walls which are serviceable from a pipe chase. Installation is achieved by threading 5 x 1/2" (13 mm) diameter threaded anchor rods to the back of the fixture. The anchor rods are then secured on the chase side of the wall by means of the supplied nuts and washers. Standard included hardware is for walls up to 8" (203.2 mm) thick. For existing walls, an optional metal cutout template is available. For new block (CMU) or poured concrete walls, an optional wall sleeve is available. rear mounted

Technical data

Toilet: HDWC2414-RM

materialstainless steel
material thickness1/16''
minimum flushing capacity6.00 liter
Overall front to back24 1/8''
overall height15''
Overall left to right14''
type of mountingrear mounted
type of toilet seatno seat
type of WCwall hung
gross weight0.00 kg
net weight0.00 kg
cUPC approvalyes
Post-consumer-recycled content56%
Pre-consumer recycled content31%
LEED MR credit 4Recycled content (1-2 points)