Franke Tap Flow Limiters

Following the recent legislation introduced for new build properties and standards introduced, we now have the facility to limit the flow rate on certain taps to a maximum of 3 litres per minute. This can be done by fitting a special type of Perlator.

However, dependant on the tap and because of the restriction introduced, invariably this would then require to have non-return valves fitted to avoid any potential back-siphonage, from the dominant cold feed.

There are two types of Flow Limiters available, one with a female thread (Pack 1) and one with a male thread (pack 2), with both being available in Chrome and SilkSteel finishes, as follows:

file
ItemContentsFinishFUN Number
Pack 1 - ChromeFlow Limiter with set of 2 (H&C) flexible tails with non-return valves Chrome 133.0082.416
Pack 1 - SilkSteelFlow Limiter with set of 2 (H&C) flexible tails with non-return valves SilkSteel133.0082.426
Pack 2 - ChromeFlow Limiter with set of 2 (H&C) flexible tails with non-return valves Chrome 133.0082.427
Pack 2 - SilkSteelFlow Limiter with set of 2 (H&C) flexible tails with non-return valves SilkSteel133.0082.428

 

These packs are available to purchase from either of our service agents: Central Services or South Services.

The two types of Flow Limiter will fit the following models of tap:

Pack 1: Female ThreadPack 2: Male Thread

Olympus
Davos ā€˜Jā€™
Eiger
Fuji
Moselle
Rotaflow
Basel
Bridge
Bridge Lever
Belfast
Rigi
Muri

 

 

 

Danube
Zurich
Davos
Top Lever
Bern
Sinos